How to pick transect spacing for a shoreline change study

Pick the wrong transect spacing and you either drown your rate table in noise or miss the hotspot that mattered. Most of the guidance out there repeats "50 meters" like it's a law of physics. It isn't. Spacing is a judgment call that depends on what the shoreline is doing and what the rate numbers are going to be used for.
What transect spacing actually controls
A transect is just a sample point along the baseline where you measure how far the waterline has moved between two dates. Space them too far apart and a short erosional stretch between two groins gets averaged away into the long, stable updrift segment next to it. Space them too close and you're generating a hundred near-identical rate numbers for a beach that behaves the same way for half a kilometer, which makes the output harder to read and doesn't buy you anything real.
The spacing decision is really a question about alignment: does your sample grid match the scale of the processes shaping that stretch of coast? A barrier island responding to a single inlet's sediment budget moves differently over tens of meters than a long, straight littoral drift beach does over kilometers. The transect interval has to resolve the first case and can afford to be coarser for the second.
Most DSAS-based studies land somewhere between 20 and 100 meters, and that range isn't arbitrary. Below 20 meters you start measuring digitizing noise and pixel-level waterline wobble as if it were real morphologic change. Above 100 meters you start smoothing past groin fields, inlet margins, and anything narrower than a few hundred meters of shoreline.
Matching spacing to what you're measuring
Start by splitting your study reach into segments that already behave differently, by eye if nothing else: an armored bluff, an open sand beach, an inlet shoulder, a nourishment cell. Set the coarse end of your range, maybe 75 to 100 meters, on the long uniform stretches where you mostly want a trend line for a report table. Tighten to 20 to 30 meters anywhere the shoreline response is going to be spatially patchy, which usually means inlet margins, structure fields, and anything within a few hundred meters of a hard point like a jetty or seawall end.
If your output feeds a capital program, where the question is which specific parcels or structures are at risk, err tight. A single uniform spacing across a 40 km study area is faster to set up but it's the kind of shortcut that shows up later as a retreat rate that doesn't match what the field crew saw at the toe of a dune.
One more factor people underweight: how many years of waterline you actually have. A two-point rate, one year to another, is sensitive to short-term storm response no matter what spacing you pick. Tighter spacing doesn't fix a thin time series. If your rate is going to drive a setback line or a permit decision, more annual waterlines matter more than a denser transect grid.
Where spacing guidance breaks down
None of this is a formula you plug numbers into. A reach with a chronic erosion hotspot that everyone already knows about doesn't need 20 meter spacing to prove it exists, it needs the long record that shows whether the rate is accelerating. A stretch that "looks" uniform on an orthophoto, on the other hand, can hide a buried seawall or a relict inlet channel that only shows up as a kink in the retreat rate once you tighten the transect spacing enough to catch it.
Treat the published ranges as a starting point, run a first pass, look at where the rate curve jumps between adjacent transects, and tighten only in those spots on the second pass. That's less work than gridding the whole reach at 20 meters up front, and it usually finds the same hotspots.
Once you've settled on a transect network, the harder part of the workflow is getting a consistent waterline for every one of those transects, every year, without a field crew re-walking the beach each season. Shoreline Change handles that piece: it extracts the waterline from an annual high-res satellite pass and reports a retreat or accretion rate for whatever segments you've already drawn.
If you've got a transect layout ready and want to see what an annual waterline layer looks like against it, that's worth a look.